proof media seal Runs the active media seal routine which moves the drum to a nvs specified position, engages the vacuum roller, rotates the drum toward the Trailing-Edge Clamp (TEC) position, then disengages the vacuum roller. Trendsetter_400/800_Proofing proof media seal The active media seal routine uses the proof type stored in the plate_loc proof NVS parameter. For this routine to work properly, make sure the parameter is correct.

../commands/proof_mode.xmlCommand: proof mode

../commands/set.xmlCommand: set

NVS:

../nvs/plate_loc_state_ptype.xmlNVS: plate_loc ptype

NVS:

../nvs/proof_cfg_ams.xmlNVS: proof ams

..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:39:14 2008 PST